Important Safety Instructions - Duerkopp Adler DACeco M-TYPE Operating Manua

DACeco M-TYPE
1

Important safety instructions

This DAC sewing machine drive is manufactured and tested in accordance with the applicable
eco M-TY PE
conditions and safety regulations and left the factory in a perfectly safe condition.
The user must observe all instructions and warning notices contained in these operating instructions in order to
maintain this condition and guarantee safe operation.
Any other use or use exceeding that specified, e.g. in the open air, in a wet or hazardous explosive environment,
is not regarded as intended use.. Use for the intended purpose includes observing the manufacturer's prescribed
conditions for operation, maintenance and repair.
The DAC will only work safely and reliably if the control unit is used in accordance with these operating
eco M-TY PE
instructions and its intended use.
Read these operating instructions carefully before unpacking and commissioning the DAC
yourself with the safety, assembly, operating and maintenance instructions before using the DAC
accessories and its additional attachments for the first time.
All operations on and with the DAC
and particular safety instructions in the following sections of the operating instructions.
All persons affected by this must be made aware of these safety instructions and must comply with them. Non-
compliance with the safety instructions may lead to personal injury, damage to equipment or malfunctions of and
damage to the drive itself.
The applicable accident prevention regulations in the respective user's country and the rules for safe and
professional working must be observed. The drive must only be assembled and commissioned by trained and
instructed persons.
Installation and commissioning of the DAC
effects of interference that may cause a risk to the health of personnel and dangerous conditions are reduced to
a minimum. Working on live parts and equipment is not permitted. Exceptions are governed by EN 50110.
Before removing covers, fitting additional attachments or accessories, e.g. reference value transmitters, photo
sensors etc., the control unit must be switched off, disconnected from the mains and you must wait until the
machine has come to a standstill [DIN VDE 0113 Teil 301; EN 60204-31; IEC 60204-31].
To reduce the risk of burns, fire, electric shock or injuries, alterations or modifications to the DAC
strictly forbidden.
No covers or protective devices may be removed during operation. Before leaving the work place, the machine's
on/off switch must be switched to the off position. If it is to be idle for long periods, the power plug must be
removed so that the drive cannot be switched on accidentally.
If additional attachments or equipment are connected to the DAC
operated at low voltage that is produced by a safety transformer.
Do not put your hands near moving parts.
Do not operate the DAC
0791 100632 EN
must only be carried out in compliance with the following general
eco M-TY PE
eco M-TY PE
if aerosols (sprays) or oxygen are being used.
eco M-TY PE
must be carried out carefully by skilled workers so that the
control unit, these may only be
eco M-TY PE
4
Important safety instructions
. Familiarize
eco M-TY PE
eco M-TY PE
eco M-TY PE
© 2013 Dürkopp Adler AG
, its
are