Connecting The Cables - Panasonic DP-1820P Operating Instructions Manual

LINK Lamp
Illuminates when connected to the LAN.
Lamp will not turn ON if LAN cable is defective
(contains breaks).
LAN Connection Jack
(10Base-T/100Base-TX)
LAN Cable
(10Base-T/100Base-TX Cable)
Insert the plug until a click is heard.
(LAN cable is not included with the product.)
Purchase a Category 5 Cable, compliant with
EIA/TIA 568-A-5 standard.
10Base-T/100Base-TX Ethernet Hub
External Telephone Jack
You can connect an additional standard
single line telephone to the machine.
To connect the telephone, remove the
protective tab on the TEL jack.
RJ-11C
Telephone Jack
16
Getting To Know Your Machine

Connecting the Cables

Ethernet LAN Cable
(10Base-T/100Base-TX)
(Not included)
ACTIVITY Lamp
Blinks when there
is data traffic
on the LAN.
Power Switch
After connecting all
cables and Power Cord,
turn the Power Switch on
the Right Side of the
machine to the ON
position.
Telephone Line Jack
Plug one end of the telephone
line cable into the "RJ-11C"
telephone jack supplied by the
telephone company and the
other end into the LINE jack on
the Right Side of the machine.
(Refer to the Dialing Method.
See page 132.)