Installing The Access Point; Before Installing; Connecting The Access Point - ActionTec GT701AP User Manual

Installing the
Access Point

Before Installing

Before installing the Access Point, be aware that this device can subject the user to
electrical shock. Follow the guidelines in this manual and the manuals of any other
equipment used during the installation. Failure to do so may result in injury or
damage to the equipment.
Important: This Access Point is a 2.4 GHz low-power RF device.
It is intended for home and office use in all EU member states
except France, where restrictive use applies.

Connecting the Access Point

To connect the Access Point to a network hub, switch, or computer (via Ethernet
cable), use the following procedure:
1. Plug one end of the Power Adapter into the Power port on the back of the
Access Point, and the other end into a power outlet. The Power LED on the
front panel of the Access Point will be red until the initialization process
begins, then blinks green. It will turn steady green when the device is ready
for service. (This may take up to 30 seconds)
2. If connecting to a network hub or switch, plug one end of a "cross-over" type
Ethernet cable (not included with the Access Point) in the LAN port on the
back of the Access Point , and plug the other end into the hub or switch. See
the figure on the next page.
10
3