Operation Of Wireless Remote Control - DèLonghi DEINV27 Owner's Manual

Operation of wireless remote control

Names and functions of wireless remote control
Note: Be sure that there are no obstructions between receiver and remote controoler;
Don't drop or throw the remote control; Don't let any liquid in the remote control and
put the remote control directly under the sunlight or any place where is very hot.
Signal transmitter
Remote control
ON/OFF button
Press this button, the unit will be turned
on, press it once more, the unit will
be turned off. Sleep function will be
canceled, while unit off.
MODE
MODE button
Press this button, AUTO, Cool,Dry,Fan,
Heat mode can be selected circularly.
AUTO MODE is default while power on.
Under AUTO MODE,the temperature will
not be displayed; Under Heat mode,
the initial value is 28
other modes,the initial value is 25
AUTO
COOL
DRY
FAN
HEAT
(only for cooling and heating unit)
82 ; Under
77
SLEEP button
Press this button, Sleep On and Sleep
Off can be selected. After powered on,
Sleep Off is defaulted. After the unit is
turned off, the Sleep function is canceled.
After Sleep function set up, the signal of
Sleep will display. In this mode, the time
of timer can be adjusted. Under Fan and 6
SENSE modes, this function is not available.
FAN button
Press this button, Auto, Low, Middle, High
speed can be circularly selected. After
powered on,Auto fan speed is default.
Auto fan
Middle fan
CLOCK button
Press to set present time and then
flashes.Press or to adjust the time
numeral segment within 5 seconds,if you
press this button for more than 2seconds,
the time will increase or decrease 10 mins
per 0.5second; if you press
the time flashing,the flash will stop and it
denotes the setting succeeded. After
powered on, 12:00 is defaulted to display
it denotes the setting succeeded. After
powered on, 12:00 is defaulted to display
and signal will be displayed. If the
displayed on the screen, that denotes
the current time value is Clock value,
otherwise is Timer value.
LIGHT button
Press this button at unit On or Off status,
Light On and Light Off can be set up. After
powered on, Light On is defaulted.
th
Low fan
High fan
again when