Table of Contents
Advertisement
Notices for installation
The unit installation work must be done by qualified personnel according to the local
rules and this manual.
Before installating, please contact with local authorized maintenance center, if unit is
not installed by the authorized maintenance center, the malfunction may not solved,
due to discommodious contacts.
W
hen removing the unit to the other place, please firstly contact with the authorized
Maintenance Center in the local area.
the appliance must be positioned so that the plug is accessible
After pull out the power plug then make the appliance operation again to avoid the
icing of outdoor unit damage axial flow fan should electrify the appliance but not
operation for 4 hours for warm-up purpose (only on some models).
This appliance has been made for air-conditioning domestic
environments and must not be used for any other purpose,
such as for drying clothes, cooling food, etc.
Basic Requirements For Installation Position
Install in the following place may cause malfunction. If it is unavoidable contact with
service center please:
Place where strong heat sources, vapors, flammable gas or volatile object are emitted.
Place where high-frequency waves are generated by radio equipment, welders and
medical equipment.
Place where a lot of salinities such as coast exists.
Place where the oil (machine oil) is contained in the air.
Place where a sulfured gas such as the hot spring zones is generated.
Other place with special circumstance.
The air inlet and outlet vent should be far from the obstruction, make sure that the air
can be blown through the whole room.
Select a position where the condensing water can be easily drained out, and the place
is easily connected for outdoor unit.
Select a location where the children can not reach.
Can select the place where is strong enough to withstand the full weight and vibration o f
the unit. And will not increase the noise.
Be sure to leave enough space to allow access for routine maintenance. The height of the
installed location should be 2 0cm or more from the floor.
Select a place about 1m or more away from TVset or any other electric appliances.
Select a place where the filter can be easily taken out.
Make sure that the indoor unit installation should accord with installation dimension
diagram requirements.
Do not use the unit in the immediate surroundings of a laundry a bath a shower or a
swimming pool.
Important Notices
Indoor Unit Installation Position Selection
Advertisement
Table of Contents
