Sony TRINITRON KV-13FM12 Service Manual page 25

5. Press then
V. Center Adjustment (VPOS)
Perform this adjustment after performing H. Frequency
(Free Run) Check.
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select the VPOS item with
4. Adjust value of VPOS with
center.
5. Press then
H. Center Adjustment (HPOS)
Perform this adjustment after performing H. Frequency
(Free Run) Check.
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select the HPOS item with
4. Adjust the value of HPOS with
horizontal center.
5. Press then
H. Size Adjustment (HSIZ)
1. Input a monoscope signal.
2. Activate the Service Adjustment Mode.
3. Select HSIZ with and
4. Adjust with and for the best horizontal size.
5. Press then
V. Linearity (VLIN), V. Correction (VSCO),
Pin Amp (PAMP), and Horizontal Trapezoid
(TRAP) Adjustments
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with
4. Adjust with and for the best horizontal size.
5. Press then
to save into the memory.
and .
and for the best vertical
to save into the memory.
and .
and for the best
to save into the memory.
.
to save into the memory.
and .
to save into the memory.
— 25 —
KV-13FM12/13FM13/13FM14/14FM12/14FM12A/14FM12C/14FM14
V LINEARITY (VLIN)
V CORRECTION (VSCO)
PIN AMP (PAMP)
HORIZONTAL TRAPEZOID (TRAP)
V. Angle (VANG), V. Bow (VBOW), Upper pin
(UPIN) and Low Pin (LPIN) Adjustments
1. Input a crosshatch signal.
2. Activate the Service Adjustment Mode.
3. Select VANG, VBOW, UPIN, and LPIN with
4. Adjust with and for the best picture.
5. Press then
V ANGLE (VANG)
V BOW (VBOW)
UPPER PIN (UPIN)
LOW PIN (LPIN)
Service Adjustment Mode Memory
1. Change the value of the DCOL item to "1".
2. After completing all adjustments, press
Read From Memory
SERVICE
and .
to save into the memory.
then
READ
Green
0
Red
ENTER
.