Lighting Panel And Controls - Volvo XC 90 Owner's Manual

Lighting panel and controls

The lighting controls on the left-side steering
wheel lever can be used to activate the vehicle's
exterior lighting. Instrument lighting brightness
can be adjusted on the lighting panel.
Ring on the steering wheel lever
Position Result
With the ignition in mode II or if
the engine is running:
•
In the US: the Daytime Run-
ning Lights (DRL) will be off
•
In Canada: the Daytime Run-
ning Lights will be on
•
High beam flash can be used
With the ignition in mode II or if
the engine is running:
•
In the US: the Daytime Run-
ning Lights will be off
•
In Canada: the Daytime Run-
ning Lights will be on
•
High beam flash can be used
With the ignition in mode II or if
the engine is running:
•
The Daytime Running Lights
will be off
•
The low beam headlights will
be on
•
High Beams/High Beam flash
can be used
Position Result
With the ignition in mode II or if
the engine is running:
•
•
A
•
•
Active High Beams On/Off
A The parking lights will be on in this position, even if the ignition
is switched off. In dark conditions, the rear parking lights illumi-
nate automatically when the tailgate is open, regardless of the
control's position or ignition mode.
B US models only: The use of Daytime Running Lights can be
activated/deactivated in the center display's Settings menu.
NOTE
The use of Daytime Running Lights is recom-
mended in the United States and is manda-
tory in Canada.
Volvo recommends using the
whenever possible.
* Option/accessory, for more information, see Introduction.
INSTRUMENTS AND CONTROLS
The Daytime Running Lights
will be on B
(the low beam
headlights will automatically
switch on in dark conditions or
if the rear fog lights are on
Tunnel detection* will be acti-
vated
Active High Beams (AHB) can
be activated
High beam flash can be used
position
}}
129