Table of Contents
Advertisement
Final check
After installation, the cable glands must be sealed with silicon to
prevent water from seeping in. Also apply silicon grease to the gasket
between the bottom and top cover.
On the inside of the feedback unit cover, a piece of moisture
protecting sponge is attached. The sponge produces a corrosion
preventive gas, and to increase the efficiency of the gas the cover
must be kept tight.
5.7
Optional equipment
AP9 MK3 Dual Station
The extra AP9 MK3 Control Unit is connected to the main control
unit according to the Dual Station Wiring Diagram. Operating
voltage and alarm voltage are supplied from the distribution unit.
The remote unit communicates through the main control unit, and
requires the main control unit switched on before use. The main
control unit and remote control unit can change places in the system.
External mode selector and NFU Lever can also be connected to the
remote unit.
FU function is not possible from Remote unit
Note !
Gyro compass with serial gyro information output (current loop and
NMEA) can not be connected to the Control Unit when a Dual Station is
connected
20169223D
.
Installation
5-19
Advertisement
Table of Contents
