Carburetor Controls - O.S. engine MAX-15CV-R Series Owner's Instructions Manual

BATTERY INTEGRATED GLOWPLUG HEATER
Commercialy available handy
glowplug heater in which the
glowplug battery and battery
leads are integrated.
FUEL PUMP
For filling the fuel tank, a simple,
polyethylene "squeeze" bottle,
with a suitable spout, is required.
LONG SOCKET WRENCH
Recommended for easy removal
and replacement of the angled
and recessed glowplug, the
O.S.Long Socket
incorporates a special grip.
SILICONE FUEL LINE
Heatproof silicone tubing of
approx. 5mm o.d. and 2mm i.d.
is required for the connection
between the fuel tank and
engine.
Wrench
CARBURETOR CONTROLS ( 10C )
Three adjustable controls are provided on this
carburetor.
The Needle-Valve:
•
For adjusting the mixture strength when the throttle
is fully open.
The Mixture Control Screw:
•
For adjusting the mixture strength at part-
throttle and idling speeds, to obtain steady
idling and smooth acceleration to mid speeds.
The Throttle Stop Screw:
•
For setting the minimum idling speed.
NOTE:
Readjustment may
be necessary, occa-
sionally to allow for
changes in fuel for-
mula, gear ratio or
clutch engagement
point.
13
Ball Link
Needle Valve
Throttle Stop Screw
Mixture Control Valve
Assembly Screw