Maintenance - Tunturi Pure Run 1.1 User Manual

After the program is confirmed, AGE
appears on the dot matrix. Using the
speed or incline arrow keys, the user
enters his/her age. Target heart rate
(THR) is computed at 65% of maximum
(220 – AGE) and appears in the heart
rate window. THR can be changed at
this time using the elevation keys. Press
START and the treadmill starts at 0.8
kph, and the user controls in the speed.
After a 3 1/2 minute warm-up, the incline
begins to adjust at a rate of 1% every 30
seconds until the target heart rate zone
is reached (THR +- 5BPM). If the THR
zone is exceeded, the incline declines at
a rate of 1% every 30 seconds until the
heart rate is in the THR zone.
8

MAINTENANCE

The equipment is safe to use only when
periodically maintained and inspected
for faults and wear.
CAUTION!
Do not attempt any servicing or
adjustment other than those described
in this manual. Any other servicing must
be performed by an authorized service
representative. Check the tightness of
all fixing screws once a year. Do not
overtighten.
CLEANING AND LUBRICATING THE
TREADMILL
FA I L U R E TO L U B R I C AT E Y O U R
T R E A D M I L L M AY I N VA L I D AT E T H E
P R O D U C T ' S WA R R A N T Y !
Wipe the treadmill surfaces, especially
the handlebars and console from dust
with a damp cloth or towel. Do not use
solvents. Use a small vacuum nozzle
to carefully vacuum around all visible
components (belt, running deck, side
rails etc.). Also keep the area near
the treadmill clean. While in use,
the treadmill gathers dust that may
cause problems in the operation of the
equipment.
In average domestic use (60 minutes a
day), you should check the lubrication
once a month – however, lubricate the
belt only if needed. In more demanding
use, the lubrication needs be checked
at shorter intervals. This is best done
before you begin a training session.
Check the lubrication as follows:
• Ensure the treadmill is powered off!
• Step on the treadmill belt .and stand
steadily where you normally run on
the belt.
• Take hold of the horizontal handlebar
and push the belt with your feet so
that it slides back and forth.
• The belt should move softly and
evenly, without a sound.
If you notice jerky movement or if the
belt will not slide check for lubrication by
sliding your hand under the belt.