Testing Burner For Leaks - Comfort Glow CVSA18M Owner's Operation And Installation Manual

Vented decorative appliances gas log
Table of Contents

Advertisement

INSTALLATION
Continued
3. Reverse the plastic pressure button and
replace it into the brass plug (see Fig-
ure 18).
4. Replace brass plug into regulator.
Figure 18 - Replacing the Plastic Pres-
sure Button in the Propane/LP position
TESTING BURNER FOR
LEAKS
1. Generously apply soapy solution to all
connections.
WARNING: Never check for
gas leaks with open flame.
2. Light the burner with the shut-off valve
no more than half open and holding a
match slightly in front of the pan (see
Lighting Instructions, page 12).
3. Inspect all connections for bubbles, raw
gas odor, or flame from any area other
than the burner (leaks). If leaks are de-
tected, shut off the gas valve immedi-
ately. Tighten, or reassemble the loose
connection(s) using pipe joint com-
pound until burner system is leak free.
4. When the burner is tested and leak free,
observe the individual tongues of flame
on the burner. Note: The burner design
includes more ports on the outside of the
bar. Make sure that all ports are clear
and producing flame evenly across the
burner. If any ports appear blocked, clear
them by removing the burner manifold
and reaming the ports with a modified
paper clip or other suitable tool.
5. When finished testing, turn the gas shut-
off valve OFF to extinguish all flames.
901051
ADDING PAN MATERIAL
1.
Open the bag of ash bed material (ver-
miculite) and spread it evenly across the
burner pan to the top. You may over-
flow the front and sides of the pan to
cover the entire pan. Do not cover valve.
2.
Open the glowing embers and evenly
cover the ash bed material (vermicu-
lite) in the burner pan.
INSTALLING THE GRATE
AND LOGS
1.
Place the grate over the burner pan
where the two outer horizontal supports
on the grate fit into the two pan posi-
tioning notches in the rear vertical edge
of the pan.
2.
Slide the two rear log grate steps over
the two outer horizontal supports on the
grate as shown in Figure 19.
3.
Place the back log on the grate onto the
grate steps (see Figure 20).
4.
Place the front log(s) on the grate and
slide forward against the front bars on
the grate (see Figure 20).
5.
Place the smaller top logs onto the bot-
tom logs (see Figure 21). Leave as
much open space between logs as pos-
sible to minimize flame impingement
and sooting. Note: Logs may chip if
they are handled roughly or if hit to-
gether while being placed.
Grate
Figure 19 - Installing Grate (Pan Material
Not Shown)
11
OWNER'S MANUAL
Grate Steps
Figure 20 - Installing Front and Back Logs
(Number and style of your logs may vary)
Figure 21 - Placement of Top Logs (Berk-
shire Split Oak Logs Shown)
Oxford Oak Logs
Amherst Oak Logs
Berkshire Split Oak Logs

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cvsa24mCpvsa18mCpvsa24mCvda18mCvda24mCvda30m

Table of Contents