cup), add into tank, put back the
safety cover and secure it firmly.
5. Check the electricity and plug,
make sure they match the require-
ment of manual, and insert the plug.
6. The steam will be ready after 4
minutes heating. Press the steam
button slightly to see if the steam
starts to release.
7. Release the button; insert different
parts according to different usage.
8. Press the steam button again; start
cleaning.
Part installation
Brush sprayer installation
Insert the Brush sprayer to the body;
follow the arrow to secure the
sprayer in a clockwise way. The
sprayer can be removed in an
opposite way.
Round or bend sprayer installa-
tion
Insert round or bend sprayer to the
short sprayer directly; follow the
instruction shows on Figure 3; adjust
the direction of the sprayer.
Flat sprayer installation
Insert brush sprayer to the short
sprayer; follow the figure 4 and 5 to
secure the brush sprayer.
Adding water
1. Remove the plug; cut off the elec-
tricity
2. Press the steam to release the
pressure until no steam is coming out.
3. Slightly open the safety cover; re-
lease the remaining steam; place the
steam cleaner in a cool place for 5
minutes; open the safety cover com-
pletely.
4. Use funnel and measuring cup to
add some cool or warm water.
5. Put back the safety cover and se-
cure it firmly
- Caution: Do not overfill, or it will
cause unnecessary steam pressure
and influence the creation of steam.
After use
1. Remove the plug after using; cut
off the electricity
2. Press the steam button to release
the remaining steam.
11