Safety And Regulatory Information For The Sonicwall Sonicpoint Wireless Appliance - SonicWALL SonicPoint-Ne Getting Started Manual

Safety and Regulatory Information for the
SonicWALL SonicPoint Wireless
Appliance
Regulatory Model/Type
APL21-06E
APL21-083
Mounting the SonicWALL
Mount in a location away from direct sunlight and sources
•
of heat. A maximum ambient temperature of 104º F (40º C)
is recommended.
Route cables away from power lines, fluorescent lighting
•
fixtures, and sources of noise such as radios, transmitters,
and broadband amplifiers
The included power cord is intended for use in North
•
America only. For European Union (EU) customers, a power
cord is not included.
• Ensure that no water or excessive moisture can enter the
unit.
Allow unrestricted airflow around the unit and through the
•
vents on the side of the unit. A minimum of 1 inch
(25.44mm) clearance is recommended.
Consideration must be given to the connection of the
•
equipment to the supply circuit and the effect of over-
loading the circuits has minimal impact on overcurrent
protection and supply wiring. Appropriate consideration
of equipment nameplate ratings must be used when
addressing this concern.
Page 38

Safety and Regulatory Information for the SonicWALL SonicPoint Wireless Appliance

Product Names
SonicPoint-Ne
SonicPoint-Ni
Cable Connections
All Ethernet and RS232 (Console) cables are designed for intra-
building connection to other equipment. Do not connect these
ports directly to communication wiring or other wiring that exits
the building where the SonicWALL is located.
Power Supply Information for APL21-083
If the power supply is missing from your SonicWALL product
package, please contact SonicWALL Technical Support at 408-
752-7819 for a replacement. This product should only be used
with a UL listed power supply marked "Class 2" or "LPS", with an
output rated 48 VDC, minimum 0.35 A, Tma: minimum 40
degrees C.
Power Supply Information APL21-06E
If the power supply is missing from your SonicWALL product
package, please contact SonicWALL Technical Support at 408-
752-7819 for a replacement. This product should only be used
with a UL listed power supply marked "Class 2" or "LPS", with an
output rated 12 VDC, minimum 1.5 A, Tma: minimum 40
degrees C.
If power is provided by the Ethernet cable plugged into the "lan"
port, this is called "Power Over Ethernet" or "POE". The POE
source should only be UL listed marked "Class 2" or "LPS", with
an output rated 48 VDC, minimum 0.35 A, Tma: minimum 40
degrees C.