Table of Contents
Advertisement
SERVICE MANUAL
Note
When disassembling, take care of small parts such as screws and washers. Put all small parts
down so that they can be reassembled in the right sequence.
· Remove legrests.
· Release seat (1) and tilt forwards.
· Disconnect the remote bus cable from the
electronics module or ACT.
· Lift the seat out of the front anchorage and
remove it. When doing so, get the help of a
second person because the seat is heavy.
· Remove both battery cases as described in
Chapter 7.7.1.
· Disconnect the motor plug from the motor to
be replaced from the electronics module.
· The motor cable is secured inside the frames
with cable ties. Remove the cable ties with
the oblique pliers.
· Place the vehicle upside down so that the
wheels are facing upwards. When doing so,
get the help of a second person because the
vehicle is heavy.
· Heat countersunk screw TX40 (1) with
hairdryer to release screw blocker system.
· Remove the torx screw (1) with a TX40
spanner.
· Pull the complete wheel off the wheel hub.
· A washer can be used to compensate the
tolerance between wheel hub and shaft
shoulder.
· When replacing the countersunk screw TX40
(1) always use a high-strength screw blocker
system such as Loctite 270!
38
®
Invacare
- Bora/Spectra XTR
Advertisement
Table of Contents
