On/Standby) Switch (1 - Sony VPL-HW40ES Operating Instructions Manual

1
After connecting the AC cord to
the projector, plug the AC cord
into a wall outlet.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
Lights in red.
2
Press the ? / 1 (ON/STANDBY)
switch to turn on the projector.
The ON/STANDBY indicator flashes in
green, and then lights in green.
Flashes in green for a
while (tens of seconds)
and then lights in green.
3
Display a test signal for
performing adjustments.
Press the PATTERN button on the
remote control to display the test signal.
Tip
Press the PATTERN button to clear the
test signal display.
4
Move both lens shift dials to
adjust the picture position.
To adjust the vertical
position
To adjust the horizontal
position
9