Kenwood KRF-V7060D Service Manual page 55

For the U.K. only
AUDIO section (KRF-V6060D)
Rated power output during STEREO operation
DIN/IEC (63 Hz ~ 12.5 kHz, 0.09 % T.H.D. at 6 Ω)
............................................................................... 100 W + 100 W
Effective power output during SURROUND operation
FRONT (63 Hz ~ 12.5 kHz, 0.09 % T.H.D. at 6 Ω one channel driven)
100 W + 100 W
CENTER (63 Hz ~ 12.5 kHz, 0.09 % T.H.D. at 6 Ω one channel
driven) ...................................................................................... 100 W
SURROUND (63 Hz ~ 12.5 kHz, 0.7 % T.H.D. at 6 Ω one channel
driven) ............................................................................. 100 W + 100 W
Total harmonic distortion ............................ 0.009 % (1 kHz, 50 W, 6 Ω)
Frequency response
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
................................................. 10 Hz ~ 100 kHz, +0 dB ~ –3.0 dB
PHONO 'RIAA' response ............... 40 Hz ~ 20 kHz, +1.5 dB ~ –3.0 dB
Maximum input level
PHONO (MM) ..................................... 45 mV, 1 % T.H.D. at 1 kHz
Signal to noise ratio (IHF'66)
PHONO (MM) ........................................................................ 75 dB
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
............................................................................................... 95 dB
Loudness control
VOLUME at –30 dB level ........................................ +6 dB (100 Hz)
Input sensitivity / impedance
PHONO (MM) ......................................................... 6.0 mV / 47 kΩ
Line (CD/DVD, TAPE, VIDEO 1, VIDEO 2, VIDEO 3, DVD/6CH)
............................................................................... 500 mV / 47 kΩ
Output level / impedance
TAPE REC ............................................................... 500 mV / 1 kΩ
PRE OUT (SURROUND BACK CHANNEL) ............... 2.5 V / 1 kΩ
PRE OUT (SUBWOOFER) .......................................... 2.5 V / 1 kΩ
Tone control
BASS ................................................................. ±10 dB (at 100 Hz)
TREBLE ............................................................ ±10 dB (at 10 kHz)
DIGITAL AUDIO section
Sampling frequency .......................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Input level / impedance / wave length
Optical .............................. (–15 dBm ~ –24 dBm), 660 nm ±30 nm
Coaxial .................................................................... 0.5 Vp-p / 75 Ω
Notes
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
KRF-V6060D/V7060D/V8060D/X9060D/VR-6050/6060/6070
SPECIFICATIONS
VIDEO section
VIDEO inputs / outputs
VIDEO (composite) ................................................. 1 Vp-p / 75 Ω
S VIDEO inputs /outputs
S VIDEO (luminance signal) ................................... 1 Vp-p / 75 Ω
S VIDEO (chrominance signal) ....................... 0.286 Vp-p / 75 Ω
FM tuner section
Tuning frequency range ....................................... 87.5 MHz ~ 108 MHz
Usable sensitivity
MONO ............... 1.3 µV (75 Ω)/ 13.2 dBf (40 kHz dev, S/N 26 dB)
STEREO ...... 45 µV (75 Ω)/ 42.1 dBf (40 + 6 kHz dev, S/N 46 dB)
Total harmonic distortion
MONO (1 kHz, 40 kHz dev) .......................... 0.2% (65.2 dBf input)
STEREO (1 kHz, 40 + 6 kHz dev) ................ 0.8% (65.2 dBf input)
Signal to noise ratio (DIN weighted at 1 kHz)
MONO .......................................................... 65 dB (65.2 dBf input)
STEREO ...................................................... 60 dB (65.2 dBf input)
Stereo separation (1 kHz) ............................................................. 36 dB
Selectivity (±300 kHz) ................................................................. 64 dB
Frequency response (30 Hz ~ 15kHz) ....................... +0.5 dB, –3.0 dB
MW tuner section
Tuning frequency range ........................................ 531 kHz ~ 1,602 kHz
Usable sensitivity (30% mod, S/N 20 dB) ................ 16 µV / (600 µV/m)
Signal to noise ratio (400 Hz, 30% mod)
............................................................ 50 dB (60 dBµ VEMF input)
GENERAL
Power consumption
AC outlet
SWITCHED ........................................................ (total 90 W max.)
Dimensions ...................................................... W : 440 mm (17-5/16")
Weight (Net) .................................................................. 9.8 kg (21.6 lb)
................................................................. 330 W
H : 159 mm (6-1/4")
D : 392 mm (15-7/16")
65