Description - Hilti SD5000-A22 Operating Instructions Manual

Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Rated speed Revolutions
under no per minute
load

2 Description

2.1 Use of the product as directed
The SD 5000-A22 is a hand-held cordless drywall screwdriver with automatic clutch.
Drywall screws with a length of up to 55 mm and a diameter of up to 4.2 mm can be used.
Do not use other types of screws intended for heavy-duty applications.
For optimum handling, we recommend that the power tool is gripped in line with the motor.
The motor cooling air is drawn in through the ventilation slots and blown out of the tool through the air exit.
The power tool is suitable for use by right or left-handed persons.
An ergonomically designed grip with synthetic rubber covering provides a comfortable, secure hold and makes the
power tool less tiring to use.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Do not use the battery as a power source for other unspecified appliances.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
Do not use the power tool where there is a risk of fire or explosion.
Modification of the power tool or tampering with its parts is not permissible.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
2.2 Main applications
Application
Fastening drywall board to metal framing ≦ 0.88 mm
Fastening drywall board to metal framing ≦ 2.25 mm
Fastening metal framing to metal framing (max. fastenable thick-
ness 2.5 mm)
Fastening drywall board to wood
Fastening drywall board to metal (≦0.88 mm) and wood framing
NOTE
The power tool can also be used together with the SMD 57 magazine and the appropriate collated screws for the
applications listed above. Please observe the operating instructions for the applicable drywall screw magazine.
Volts Direct
current
Diameter
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 01
Serial no.:
Screw type
Drywall screw with needle point,
type S‑DS01
Drywall screw with drill point, type S‑DD01
Drywall screws with drill point, types
S‑DD02, S‑DD03 and S‑DD08
Drywall screw with needle point,
type S‑DS03
Drywall screws with needle point, types
S‑DS14 and S‑DS10
en
15