Sanyo PLC-WXU10N Service Manual page 6

Attention for handling
♦
Do not touch the lamp until it has cooled completely, because the lamp is very hot during
operation and immediately after turned off.
♦
The lamp has to be fixed firmly to the base or socket.
♦
Turn off the power supply during maintenance.
♦
Do not hold the lamp except outer surface of the reflector.
♦
Wear protective gloves and eyeglasses when handling the lamp.
♦
Any unusual shock or vibration to the lamp should be avoided.
♦
The lamp contains the mercury. Its breakage might cause mercury to flow out of the
reflector. Please manage provision at the customer's product.
♦
Do not pull the lead wire and plug by more than 24.5N.
♦
Please be careful of handling the lamp because it is made of glass.
♦
Please notice for keeping or handling the lamp, because there is a projection of this lamp
with reflector ahead.
♦
Do not touch the bulb and the mirror area of the reflector.
Attention for use
♦
Do not close or cover the lamp with any flammable stuff.
♦
During operation, the lamp is under extremely high pressure. Please manage provision at
the customer's product to prevent fragments of bulb and mercury from flowing out of it. If
the lamp bursts in case of an emergency, the sound will be occurred.
♦
Lamp operation should be with the specified lamp driver and the system ONLY.
♦
Do not look at the lamp directly during operations.
♦
Do not expose your skin directly. We recommend to you to put on something for
protection for your skin. For example, long sleeve shirt, gloves, glassed and so on.
♦
Do not modify the lamp and never use a lamp that has been modified.
♦
Any unusual shock or vibration to the lamp should be avoided during operation.
♦
Do not use any broken lamps.
♦
Dispose of used lamps according to your local instruction.
♦
Do not turn on the lamp while the system is opened.
♦
The lamp contains mercury. If the lamp bursts during operation ventilate the area
sufficiently to avoid inhaling harmful mercury fumes.
♦
Use the lead below 200
resin.
♦
The lead wire insulation clad shouldn't touch the reflector.
♦
Exchange the lamp that has already passed the life time immediately.
PLC-WXU10
。 C to prevent a deterioration of cladding clad of the fluorocarbon
3