Sanyo PLC-WXU10N Service Manual page 50

2. Check flicker
Step 1: Enter the Engineering mode.
Choose the EPSON Flicker item then press right button on the panel.
Step 2: Adjustment OSD will show on the screen as below.
The OSD disappear at this moment as shown.
i. Choose the " Red Flicker " then press the right and left button to adjust the red color flicker.
The value of flicker will be saved automatically when the flicker is the best situation.
ii. Choose the " Green Flicker " then press the right and left button to adjust the green color flicker.
The value of flicker will be saved automatically when the flicker is the best situation.
iii. Choose the " Blue Flicker " then press the right and left button to adjust the blue color flicker.
The value of flicker will be saved automatically when the flicker is the best situation.
The new value of flicker will be set on the next time and can not be reset to default value. Please choose the
Reset Flicker Value if you need recovery to default value.
Step 3: Press the Menu button to return the normal screen when you complete the flicker adjustment.
PLC-WXU10 47