Headlamp Exit Delay; Daytime Running Lamps - Lincoln 2015 MKS Owner's Manual

Hide thumbs Also See for 2015 MKS:
Table of Contents

Advertisement

Press and hold the top of the control to
the second detent to switch the interior
lights on.
Press and hold the bottom of the control
to the second detent to switch the interior
lights off.

HEADLAMP EXIT DELAY

After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You will
hear a short tone. The headlamps will switch
off automatically after three minutes with
any door open or 30 seconds after the last
door has been closed. You can cancel this
feature by pulling the direction indicator
toward you again or switching the ignition on.
MKS (), enUSA
Lighting

DAYTIME RUNNING LAMPS

Equipped)
WARNING
The daytime running lamps system
does not activate the tail lamps and
may not provide adequate lighting
during low visibility driving conditions. Also,
the autolamps switch position may not
activate the headlamps in all low visibility
conditions, such as daytime fog. Always
ensure that your headlamps are switched to
auto or on, as appropriate, during all low
visibility conditions. Failure to do so may
result in a collision.
Type 1 - Conventional (Non-
Configurable)
When you switch the ignition to the on
position and the lighting control is in the off,
autolamps or parking lamp position, the
daytime running lamps will turn on whenever
the headlamps are off. They turn off only
when the headlamps are on.
I n f o r ma t i o n P r o v i d e d b y :
73
Type 2 - Configurable
(If
Note: If this type is equipped, you are able to
switch the daytime running lamps on or off
using the information display controls. See
Information Displays (page 88).
When the daytime running lamps are
switched on in the information display and
you switch the ignition to the on position with
the lighting control in the autolamps position,
the daytime running lamps turn on whenever
the headlamps are off.
The other lighting control switch positions
do not activate the daytime running lamps
and can be used to temporarily override
autolamp control.
When switched off in the information display,
the daytime running lamps are off in all
lighting control switch positions.

Advertisement

Table of Contents
loading

Table of Contents