How To Control The Amount Of Water Supplied To Icemaker - LG LSC26905TT Service Manual

HOW TO INSTALL THE REFRIGERATOR

3. How to Control the Amount of Water Supplied to Icemaker.

3-1. Confirm the amount of water supplied to the icemaker.
1. Pull out the ice bin shelf in the upper part of the freezer compartment.
2
1
2. Trun on the electricity after connecting water pipe.
1) Press the test switch under the icemaker for two seconds as shown below.
2) The bell rings(ding~dong), the ice tray rotates, and water comes out the icemaker water tube.
3) The water is supplied into the tray two or three times. The amount is smal each time.
Put a container under the ice tray and press test switch.
4) When the ice tray rotates, the water in it will spill. Collect the spilled water and discard it.
5) When ice tray has finished rotation, water comes out the water tube. Check the amount that goes into the ice tray. (Refer
to the drawing below. The optimum amount is 110cc.(almost 4 oz.))
Confirm the amount
of water
* It is acceptable is the adjusted water level is less than the optimum level.
Caution : • Do not put hands or tools into the chute to confirm
the operation of geared motor.
It may damage the refrigerator or hurt your hands.
Too much
Optimum level
Too little
- 14 -
Icemaker
Test Switch