Getting Started; Installing The Dash Camera Memory Card; Mounting And Powering The Nüvicam Device In Your Vehicle; Acquiring Gps Signals - Garmin nuviCam Owner's Manual

Getting Started

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
• Install the camera memory card
Memory Card).
• Update the maps and software on your device
Maps and Software with Garmin
• Mount the device in your vehicle and connect it to power
(Mounting and Powering the nüviCam Device in Your
Vehicle).
• Align the dash camera (Aligning the
• Acquire GPS signals (Acquiring GPS
• Adjust the volume (Adjusting the
brightness (Adjusting the Screen
• Navigate to your destination

Installing the Dash Camera Memory Card

Before the device can record video from the integrated dash
camera, you must install a camera memory card. The camera
requires a microSD ™ or microSDHC memory card up to 64GB
with a speed rating of class 4 or higher. You can use the
included memory card, or you can purchase a compatible
memory card from an electronics supplier.
1
Insert a memory card
NOTE: If you install the memory card into the incorrect slot,
the camera cannot record video.
2
Press it in until it clicks.
Mounting and Powering the nüviCam Device
in Your Vehicle
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Both the device and its mount contain magnets. Under certain
circumstances, magnets may cause interference with some
internal medical devices, including pacemakers and insulin
pumps. Keep the device and its mount away from such medical
devices.
Both the device and its mount contain magnets. Under certain
circumstances, magnets may cause damage to some electronic
devices, including hard drives in laptop computers. Use caution
when the device or its mount is near electronic devices.
Before you use your device on battery power, you should charge
it.
1
Press the mount onto the suction cup
place.
Getting Started
WARNING
(Installing the Dash Camera
(Updating
Express).
Camera).
Signals).
Volume) and display
Brightness).
(Starting a Route).
into the camera memory card slot
WARNING
NOTICE
until it snaps into
2
Open the lever , press the suction cup to the windshield,
and flip the lever back toward the windshield.
The lever must be oriented toward the top of the windshield.
3
Extend the suction cup arm
. 4
If necessary, rotate the mount so the Garmin
right-side up.
5
Plug the vehicle power cable
6
Place the back of the device onto the mount.
7
Plug the other end of the vehicle power cable into a power
outlet in your vehicle.

Acquiring GPS Signals

To navigate with your device, you must acquire satellites.
the status bar indicates the satellite signal strength. Acquiring
satellites can take several minutes.
1
Turn on the device.
2
Wait while the device locates satellites.
3
If necessary, go outdoors to an open area, away from tall
buildings and trees.

Status Bar Icons

The status bar is located at the top of the main menu. The status
bar icons display information about features on the device. You
can select some icons to change settings or view additional
information.
GPS signal status
Bluetooth technology status (appears when Bluetooth is
®
enabled)
Current time
.
® logo faces
into the port on the mount.
in
1