Component Video - Sony Trinitron KV-XA34 Operating Instructions Manual

Connecting a DVD player using the t (video input) jacks
DVD player
LINE OUT
R-AUDIO-L
VIDEO
Audio/Video cable
(not supplied)
Connecting a DVD player using the
input) jacks
1 Connect R and L under
AUDIO R and L output connectors on your DVD player.
2 Using a component video cable, connect Y, C
input) on your TV to the COMPONENT VIDEO OUT Y, C
connectors on your DVD player.
DVD player
COMPONENT VIDEO OUT S VIDEO OUT
C C Y
R B
To audio
output
To component
video output
Notes
• Some DVD player terminals may be labeled differently:
• Since the high quality pictures on a DVD disc contain a lot of information,
• Connect your DVD player directly to your TV. Connecting the DVD player
(component video input) on your TV to the LINE OUT,
LINE OUT
R-AUDIO-L
VIDEO
To
L (white)
R (red)
Audio cable
(not supplied)
Component video cable
(not supplied)
Connect To (on the DVD player)
Y (green) Y
C (blue) C , B-Y or P
B b
C (red) C , R-Y or P
R r
picture noise may appear. In this case, adjust the sharpness ("SHARP") in
the "ADJUST" menu of the "PICTURE MODE" menu (see page 22).
through other video equipment will cause unwanted picture noise.
1 2 3
L(MONO)
R
To t 1, 2, or 3
(video input)
(yellow)
-L (MONO) (white)
-R (red)

(component video

, and C under
B R
, and C
B
R L Y C C
B
To
(component
video input)
B
R
Rear of TV
: Signal flow
(component video
output
R
Rear of TV
R
: Signal flow
Using Your New TV
7