Machine Storage - Bissell PROdry 7350 SERIES User Manual

M
aintenance and care
Cleaning/replacing the TLR Power Roller
1. Turn power switch to OFF ( O ) and unplug
the machine.
2. Remove both tanks, detent the handle and
turn the machine on its back.
3. Remove the 6 screws from the sole plate
using a Phillips head screwdriver, set 6
screws and sole plate aside.
4. Turn the machine on its side so the cord side
is against the floor.
5. Remove the 2 screws from the belt guard
and set aside (Note: These 2 screws are the
same as the 6 sole plate screws). Remove
the top of the belt guard and brush dowel.
6. Unhook the belt from the TLR PowerRoller
and slide the roller down through the hole in
the belt guard bottom.
7. Clean the TLR PowerRoller by rinsing with
hot water and mild soap. Allow to dry before
replacing if desired.
8. To replace, push the cog of the TLR
PowerRoller back up through the hole and
re-attach the belt. Slide the dowel back
down through the TLR PowerRoller and line
the top of the belt guard over the bottom
half. Replace the 2 screws.
9. Turn the machine on to its back and
attach the second swing arm. Be sure the
arm is properly in place both on the TLR
PowerRoller and in the base. Push the TLR
PowerRoller down so it is nested under the
nozzle.
10. Re-attach the sole plate using the 6 screws.

Machine storage

Put the unit away in a closet or basement for
the next use. Store cleaner in a protected, dry
area. Since this product uses water, it must not
be stored where there is a danger of freezing.
Freezing will damage internal components and
void the warranty.
w w w . b i s s e l l . c a
3.
5. 6.
8a. 8b.
8c.
9.
11
8 0 0 . 2 6 3 . 2 5 3 5