Washing Cycle Complete/Removing The Washing - AEG LAVAMAT W 1020 Instruction Book

Washing Cycle Complete/Removing the Washing

The washing program normally ends with the final spin.
After a rinse hold:
After a rinse hold the water must first be pumped out or the washing
spun:
0 1. Release the
2. Either turn the program selector clockwise to
or
(the washing is spun according to the selected program and the spin
speed set)
or
turn the program selector clockwise to
(the water is pumped out).
Once the program is finished:
For safety reasons, the door remains locked for 1-2 minutes after the
3
end of the program.
0 1. Open the door.
2. Remove the washing.
3. Press the
The indicator extinguishes, the washing machine is switched off.
4. Close the water tap.
5. Pull out the detergent drawer a little so that it can dry out. Leave the
door slightly ajar so that air can circulate in the washing machine.
Important! If the washing machine is not to be used for a long period:
close the tap and isolate the washing machine from the mains.
(RINSE HOLD) button.
(SHORT SPIN)
(ON/OFF) button.
Operating instructions
(SPIN)
(PUMP OUT)
21