Sony WEGA KV-BZ212 Operating Instructions Manual page 5

D
Setting up your TV ("Initial Setup")
When you turn on your TV for the first time, the "Initial Setup" menu will
appear. You may change the menu language, preset the TV channels
automatically, edit the channels and adjust the picture position using the
buttons on the remote control or TV top control panel.
1
Press V or v to select the desired menu
language, then press
The selected menu language appears.
2
Press V or v to select "Yes", then press
preset the channels automatically.
The screen will indicate automatic
presetting is in progress.
After all available channels have been tuned
and stored, the "Program Edit" menu
appears automatically on the screen.
To skip automatic channel presetting, select
"No", then press
If the message "No channel found. Please
connect cable/antenna" appears, check your
TV connections, then press
3
The "Program Edit" menu enables you to
edit the channels.
a) If you wish to keep the channels in the current
condition, press WEGA GATE to exit.
b) Press V or v to select the program
number with the channel you wish to
change. The selected channel will appear
on the screen.
c) If you wish to edit the channels, press
to enter edit mode.
Press b until the mode that you wish to edit
is highlighted: Label, Skip,
Then press
1) To label, press V or v to select the
alphanumeric characters for the label.
Then press
.
.
.
(block symbol).
.
.
Select
to
Select
Program:
Searching...
Program Edit
Edit:
Select
Select
Confirm End
Confirm End
1
End
PROG Label Skip
1 Off
2
Off
3
Off
4
Off
Confirm Exit
Confirm Exit