Gear And Pump Assembly - Allpro 400E Operations Manual & Parts List

GEAR AND PUMP ASSEMBLY

FIGURE 12
1
8
7
15
16
14
WARNING
- Do not operate
machine without cover guard in place.
FIGURE 12 PARTS LIST
ITEM NO. PART NO.
1 331-234SI
2 331-046
3 331-038
4 331-039A
331-039
331-039B
5 331-047
6 331-040
7 100-381
8 100-380
9 331-061
10 331-065
12 331-062
13 331-010
14 100-318
15 331-074
16 331-111
17 331-219
18 331-197
19 331-103
2
9
19
18
13
DESCRIPTION
Cover Ass'y
Bearing
Crosshead Assembly
Gear Crank
(400E)
Gear Crank
(500E)
Gear Crank
(600E)
Bearing
Box
Screw Soc Hd (2)
Shoulder Screw (2)
Sleeve Bearing
Pin
Retaining Spring
Paint Pump Assembly
Screw (2)
Tube Spacer (2)
Cover - guard
Gasket
Screw (2)
Washer (2)
5
4
3
17
10
12
SERVICING GEAR BOX
ASSEMBLY
1. Remove fluid pump as per "Fluid Pump Discon-
nect" procedures page 18.
2. Remove frame by removing four screws. ( See
Item 20, Fig. 17)
(Refer to Fig. 12 for the following steps 3 - 7)
3. Separate the cover assembly (1) from box (6) by
removing screws (7) from front of cover and
back of box and shoulder screws (8) from front
of cover and back of box.
4. Lay unit on its back and disassemble gearbox.
5. Inspect bearings (2) and (5), Crosshead Assem-
bly (3), Gearcrank (4) and sleeve bearing (9)
inside cover assembly for wear or damage.
Replace worn or damaged parts.
6. If gear grease needs replacing, replace with gear
grease (Part No. 331-132)
7. Clean mating surfaces of cover and box thoroughly
and seal with gasket (17).
8. Reassemble in reverse order.
Note: Box (6) can be ordered separately, but is included
with motor ass'y. (PN 331-070, 331-068)
7
8
6
19