Siemens M35 Series Service Manual page 48

Jumper Settings of NGSM(Power Supply
Internal dip switches of the power supply, NGSM 32/10, must be set correctly to ensure
proper communication between PC and the NGSM. These switches are set up by Siemens
and tested before delivery, hence it is not necessary to change it normally.
These switches are located under the left side of the cover of the NGSM.
Position
Switch No.
TABLE A.6 SWITCH SETTINGS
Test SIM card Information
For testing purposes, in combination with the Rohde & Schwarz GSM tester, CMD or CTS, it is
mandatory to use the enclosed test SIM card.
If you do not use this test SIM card, you will encounter difficulties in getting correct measurement
for the Bit Error Rate.

When the SIM card simulation is set to '1' in the INI file, then this
There are two different PIN numbers stored in the SIM card. The PINs and
their respective Master-PIN are:
PIN 1
Master-PIN 1
PIN 2
Master-PIN 2
TABLE A.7 D25 TO D25 CONNECTION
OFF ON OFF OFF ON OFF OFF ON
1 2 3
test SIM card is not needed at all
4 5 6 7
12 34
76 54 32 10
56 78
98 76 54 32
8