Related Manuals for Siemens S35i
Summary of Contents for Siemens S35i
- Page 1 Modem Command Set Reference Manual Manual Reference Modem Commands for the SIEMENS Mobile Phone S35i, C35i, M35i page 1 of 7...
- Page 2 Modem Command Set Reference Manual The command descriptions or example sequences in this document imply no liability or warranty in any way. The author therefore will take no responsibility and will accept no liability which results of using the content of this document in any way. All rights reserved.
-
Page 3: At Command Set
Modem Command Set Reference Manual 1. AT Command Set A command entered at the user port generally starts with a command prefix consisting of the characters ‘AT’. The remainder of the line is interpreted as a sequence of the commands described below. The commands are not case-sensitive. - Page 4 Modem Command Set Reference Manual Command Function (default values in Implementation comments Reference bold type ) call. An ISDN connection to a V.110 terminal adapter will be established. The data transmission speed is the same as for an ‘analog’ call (2400 / 4800 / 9600 / 14400 bps).
- Page 5 Modem Command Set Reference Manual Command Function (default values in Implementation comments Reference bold type ) As ATX1 V.25 ter As ATX1, but report BUSY V.25 ter As ATX3 V.25 ter Reset to default configuration V.25 ter &C[n] Circuit 109 (Received line V.25 ter signal detector / DCD) behaviour...
- Page 6 ‘connect’ message n = 1 /REL or /RLP appendix with the ‘connect’ message No action No action No action No action ^S... Routed to MS See gsatxsie.c. DNT, Siemens Table 1: Basic AT Commands page 6 of 7...
- Page 7 Modem Command Set Reference Manual The commands in Table 2 are used to configure the modem .All other AT commands specified by leading +C are descripted in the AT Command Set Reference Manual. Command Function, defaults Implementation comments Reference +CBST 7,0,1 (9600 bps) GSM07.07 +CRLP...