Table 2.2 Transfer Rate Setting Values (For Fc-Al Connection); Table 2.3 Fc Port Parameter Settings (Fabric Connection); Table 2.4 Transfer Rate Setting Values (For Fabric Connection) - Fujitsu ETERNUS DX80 S2 Configuration Manual

Chapter 2 Setting Up the ETERNUS DX
2.1 Common Settings
*1: Set the appropriate value from the following table. Do not use [Auto-negotiation].

Table 2.2 Transfer Rate setting values (for FC-AL connection)

Fibre Channel card maxi-
mum speed
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s

Table 2.3 FC port parameter settings (Fabric connection)

Parameter
Connection
Transfer Rate
FC Frame Size
Reset Scope
Release Reservation if Chip is Reset
*1: Set the appropriate value from the following table.

Table 2.4 Transfer Rate setting values (for Fabric connection)

Fibre Channel switch maxi-
mum speed
16Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
*1: Specify "Auto Negotiation" for direct connections to 16Gbit/s Brocade Fibre Channel cards.
When using a Fabric connection, complete the preparatory work and set up the Fibre Channel switch be-
forehand. For setting details, refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connec-
tion- (Fibre Channel) Fibre Channel Switch Settings" or "Fabric OS Administrator's Guide".
Transfer rate setting value
16Gbit/s CA
—
8Gbit/s
4Gbit/s
—
Transfer rate setting value
16Gbit/s CA
16Gbit/s (*1)
8Gbit/s
4Gbit/s
—
9
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
8Gbit/s CA
8Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
Setting value
Fabric
See the table below (*1)
2048
I_T_L
Disable
8Gbit/s CA
8Gbit/s
8Gbit/s
4Gbit/s
2Gbit/s
4Gbit/s CA
4Gbit/s
4Gbit/s
4Gbit/s
2Gbit/s
4Gbit/s CA
4Gbit/s
4Gbit/s
4Gbit/s
2Gbit/s
P3AM-5332-15ENZ0