Step 3: Testing Alarm - Kidde 10SCO User Manual

2540-7205-02_10SCO(KN-COPE-D).qxd:_
Operating and Installation Instructions
allows for aesthetic alignment). Note: The alarm will
mount to the bracket in 4 positions (every 90 degrees).
5. Two labels are included with your alarm. They have impor-
tant information on what to do in case of an alarm. Add
the phone number of your emergency service provider
(for smoke or fire emergencies call '999' or for CO gas
emergencies call 0800 111 999) in the space provided.
Alternatively, for solid fuel emergencies call HETAS (0845
634 5626) or for oil based emergencies call Oftec (0845
658 5080). Place one label next to the alarm after it is
mounted, and one label near a fresh air source such as a
door or window.
6. Pull the Battery Pull Tab (yellow tab protruding from unit)
completely out of unit. This will automatically connect
the battery.
Step 3: Testing the Alarm
CAUTION: Due to the loudness (85 decibels) of the
!
alarm, always stand an arms length away from the
unit when testing.
The test/reset button has four purposes. It tests the unit's
electronics, resets the CO alarm, activates the HUSH
feature, and activates the Peak Level Memory Feature.
After installation, TEST THE UNIT'S ELECTRONICS by
pressing and releasing the test/reset button. A series of
beeps will sound, followed by the message "Fire! Fire!"
then another two series of beeps and the message
"WARNING! CARBON MONOXIDE!" followed by 4
additional short beeps.
Weekly testing is required! If at anytime it does not perform
as described, verify that the battery doesn't need replacing.
Clean dust and other buildup off the unit. If it still doesn't
operate properly call the Consumer Hotline at 0800 917
0722.
HUSH ® Control Feature
The HUSH ® feature has the capability of temporarily
desensitizing the smoke alarm circuit for approximately 10
minutes. This feature is to be used only when a known
alarm condition, such as smoke from cooking, activates the
alarm. You can put your Smoke/CO Alarm in HUSH ® mode
by pushing the test/reset button. If the smoke is not too
11
2014.3.21 10:48 AM