Install The Ink Tanks - Canon imagePROGRAF iPF770 Series Setup Manual

Install the Ink Tanks

1
Press the power button to turn on the
printer.
4
Instructions on ink tank installation
are shown on the display screen. As
instructed, grab the handle on the ink tank
cover to open it.
7
Open the pouch and remove the ink tank.
• Never touch the ink holes (a)
or metal contacts (b). Touching
these parts may cause stains,
damage the ink tank, and affect
print quality.
• Avoid dropping the ink tank after
removing it from the pouch.Otherwise,
ink may leak and cause stains.
Do not remove and shake ink tanks that
•
have already been installed in the printer
because ink may leak out.
10
Repeat steps 5 to 9 to install all of the ink
tanks.
Install the 6 ink tanks.
2
When the following screen appears, use
the ▲ and ▼ keys to select a language
and press OK.
5
While pressing the stopper of the ink tank
lock lever inwards, open the ink tank lock
lever upwards.
8
Insert the ink tank into the holder facing
as shown, with the ink holes down.
At this time, detach and reattach the ink
tanks 2 to 3 times and ensure that the ink
tanks are security attached.
a
b
• If the ink tank does not fit in the holder,
make sure the color of the ink tank lock
lever matches the color of the ink tank, and
check the orientation of the ink tank.
11
Close the ink tank cover.
Language
English
Français
Data
Italiano
Deutsch
Message
3
3
Select your local time zone and press OK.
Time Zone
0:London (GMT)
+1:Paris,Rome
+2:Athens,Cairo
Data
+3:Moscow
+4:Eerevan,Baku
Message
Power
Load FEED Cut
Menu Stop
Navigate
Back
6
Shake the ink tanks gently  to 2 times
before opening the pouch.
• Failure to shake ink tanks may result in
reduced print quality because ink ingredients
have settled on the bottom of the tank.
• If the ink tank is cold, allow it to adjust to
room temperature before attaching it to the
printer.
9
Close the ink tank lock lever until it clicks
into place. Make sure the ink lamp is lit in
red.
• If the ink lamp is not lit, repeat steps 5 and
9.