Adjusting The Video - Pioneer BDP-150 Operating Instructions Manual

Setting
Screen Saver
Auto Power Off
Quick Start
Update
Load Default
System Information
Disc Auto Update
BUDA
 Adjusting the video
Select and set Display Setting  Video Adjust 
1
Next Screen.
Use / to select, then press ENTER.
2 Select the item and change the setting.
Use / to select the item, then use / to change the
setting. Once the setting is completed, press
RETURN to close the settings screen.
Item Description
Brightness Select this to adjust the TV screen's
brightness.
Contrast Select this to adjust the TV screen's
contrast.
Hue Select this to adjust the color (green and
red) balance of the TV screen.
Saturation Select this to adjust the TV screen's
saturation.
Options Explanation
Off The screen saver is not activated.
1 min The screen saver will be activated if no operation has been performed for
more than one minute/two minutes/three minutes. Operating the remote
2 min
control can deactivate the screen saver.
3 min
Off Select this if you do not want the power to turn off automatically. This is the
default setting for models other than European models.
10 min The power will be automatically turned off if no operation has been performed
for more than 10 minutes/20 minutes/30 minutes. The default setting for
20 min
European models is 30 minutes.
30 min
On Select to shorten the required time to boot up.
Off Select to perform normal bootup.
Disc Select the method of software updating. (page 39)
USB Storage
Network
Restore the settings to the factory default.
Check the system version number.
On Display the software update screen when the disc with the player's update
file is loaded.
Off The software update screen must be displayed manually. (page 39)
BUDA Information Display and set up the BUDA data on the connected USB device.
BUDA Setup
 Setting the IP address
Select and set Network  IP Setting  Next
1
Screen.
Use / to select, then press ENTER.
2 Set IP address.
Use /// to set the IP address of the player or DNS
server, then press ENTER.
• Auto Set IP Address
On – The player's IP address is obtained
automatically. Select this when using a broadband
router or broadband modem that has a DHCP
(Dynamic Host Configuration Protocol) server
function. This player's IP address will automatically
be allocated from the DHCP server.
Off – The player's IP address must be set manually.
Use the number buttons (0 to 9) to input the IP
address, subnet mask and default gateway.
Note
• For information on the DHCP server function, refer to
the operating instructions for the network device.
• You may need to contact your Internet service
provider or network administrator when inputting the
IP address manually.
07
37
En