On Timer Operation - Daikin FTXG20LV1BW Operation Manual

ON TIMER Operation

NOTE
„ In the following cases, set the timer again.
• After a circuit breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
„ To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
1.
Press
• " " and day of the week disappear from the LCD.
2.
Press until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the setting rapidly.
3.
Press
• " " and setting time are displayed on the LCD.
• The multi-monitor lamp blinks twice.
The TIMER lamp periodically lights orange.
Display
„ To cancel ON TIMER operation
Press
• " " and setting time disappear from the LCD.
• " " and day of the week are displayed on the LCD.
„ To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Page 10
.
• " " is displayed on the LCD.
• " " blinks.
again.
.
Combined
Page 5
22