Advertisement
BeeLINK2 connections.
The IR/ sense socket is output for the IR-emitter that sends IR to the device to be
operated. In some cases this socket is also used for sensing purposes. Sometimes the
BeeLINK2 controller needs to know if the device is powered up or not.
In some cases this socket is used for other serial communication like RS-232 instead of IR
control.
Prog switch is a push button that must be activated to initiate a programming sequence, as
described in the option programming chapters.
Do not use socket is for firmware updating of the controller. If used for anything else, the
controller may be damaged.
LED indicates different operating modes:
Red-green flash:
Red flash:
Red:
Green:
Short light off:
No data has been received since power has been applied
The controller is in option programming mode.
The controller is active.
The controller is inactive.
When the controller sends data, the LED turns off 1 sec.
A BeeLINK2 controller connects to the BeeBUS via a RJ45
connector and CAT5 cable.
Warning:
If connected to a computer network,
this is likely to be damaged.
Connect only to a BeeLINK bus.
Advertisement
