Advertisement
Power off option
Most beeLINK controlled devices will automatically power on, when they are selected.
But it is not always practical if a device automatically powers off, when another source is
selected or the TV is turned off.
An example could be a Satellite receiver that is being used in more than one room. If a
user in a linkroom is watching programmes from the receiver, it is not practical that the
receiver automatically powers off, when the user in the main room turns off the TV or
selects another source. If a recorder has been timed to record from the receiver, it would
also be a problem if the system automatically powers off the receiver.
Many devices use so much time running a booting sequence that you might want them to
never power off, for this reason only.
The PowerOff option makes you select different ways to power off a device. This device
has following PowerOff options available:
Option
Function
031
Power off using the
032
Power off using the
033
Power off disabled. Use manual power button
An option programming sequence is initiated by pressing the little red switch on the BeeLINK2 controller, until
its LED starts flashing. Hereafter the 3 digit option code must be entered with the B&O remote control.
Tip.
In a setup that includes a TV, this should be set with option 031. Some or all set top boxes should be set with
option 032. When the user turns off the TV after a session, a short press on the standby button will turn off the
TV only, and a long press on standby will turn of all of the set top boxes as well.
w
button. Press shortly.
w
button. Press 2 seconds for global standby.
*1
Some BeeLINK controllers need to know the power status
from the device, in order to power it on and off
automatically.
This controller uses a OneRemote IR-emitter with a DC
type scartplug, to measure on the device. OneRemote type
34090051.
The scartplug must be inserted in the devices TV-scart
socket.
*1
O9
to power off the device.
*1
Advertisement
