Acura TSX 2007 Owner's Manual page 139

When you open the driver's door
after unlocking it with the remote
transmitter, you will hear a beep
(depending on the ''KEYLESS
LOCK ACKNOWLEDGEMENT''
setting see page 113 ). The driver's
seat will move to the positions stored
in the memory location
corresponding with the remote in
use. You will hear two beeps when
the seat stops moving.
Any of these actions will stop the
system's automatic seat adjustment:
Pressing either memory button or
the MEMO button on the driver's
door.
Pressing any of the seat
adjustment switches.
Shifting out of Park (A/T), or into
reverse (M/T).
The driving position memory
activated (Driver 1, Driver 2) is
shown on the back of each
transmitter. Make sure you store
your desired driving position in the
memory that is activated by the
transmitter you normally carry.
You can turn off this system
activation. Press and hold the LOCK
and UNLOCK buttons at the same
time. The LED in the remote
transmitter will blink twice. Then
release the buttons. Doing this also
cancels the ''MEMORY POSITION
LINK'' setting for that remote and
restores the default settings.
To turn it back on, repeat this
procedure. The LED will come on
for 1 second to indicate the feature
has been turned on.
Remote Transmitter
Remote Transmitter Care
Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
Replacing the Transmitter Battery
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR2025
CONTINUED
133