AT&T Hot Joe IIPWS02 User Manual

Portable bluetooth speaker

Advertisement

Quick Links

user's
manual
Hot Joe II
model #: PWS02
Portable Bluetooth
Speaker
®

Advertisement

Table of Contents
loading

Summary of Contents for AT&T Hot Joe IIPWS02

  • Page 1 user’s manual Hot Joe II model #: PWS02 Portable Bluetooth Speaker ®...
  • Page 2: What's Included

    What’s Included Unpack the Hot Joe II and make sure all accessories are put aside so they will not be lost. hello. Micro USB Cable Thank you for purchasing Hot Joe II [PWS02]. Portable Bluetooth Speaker ® Features • Bluetooth 2.1 + A2DP, AVRCP •...
  • Page 3: Table Of Contents

    Contents Safety Information Important Safety Instructions Introduction Please read all safety and operating instructions carefully before What’s Included installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in this user’s Safety Information manual and on the PWS02.
  • Page 4: Getting Started

    Getting Started Operational Instructions Location of Main Unit Controls Charging the Unit 1. Charge your Unit through any Micro USB Jack or wall charger. 2. The LED indicator will turn red while charging. 3. Once the battery is fully charged the red indicator will turn off. Note: Please charge the battery up to 4 hours before initial use.
  • Page 5: Pairing Your Bluetooth Device

    Operational Instructions Contents Operational Instructions Pairing Your Bluetooth Device Hands-free Speakerphone Placing a Call 1. Turn the Hot Joe II ON. The Hot Joe II will beep and the indicator - To place a call simply initiate the call from your Bluetooth will turn blue and will flash indicating the unit is in pairing mode.
  • Page 6: Compliance With Fcc Regulations

    Contents Troubleshooting Compliance with FCC Regulations Caution! Symptom Possible cause The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s No power Recharge the battery. authority to operate the equipment. The equipment has been tested and found to comply with the limits for a Move the power switch to Class B digital device, pursuant to Part 15 of the FCC Rules.
  • Page 7: Warranty Information

    Warranty Information Warranty Information Limited Warranty Concept 101 LLC does not warrant that the unit will work properly in all environmental conditions, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose other than the purpose identified The AT&T brands are used under license.
  • Page 8 www.att.com/electronics ©2015 Concept 101 LLC. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Concept 101 LLC, New York, New York 10018. Issue 1.1 AT&T 1/2015.

This manual is also suitable for:

Hot joe ii pws02

Table of Contents