Error Messages - Symbol Series 3300 System Administration Manual

Series 3300 System Administration Manual

Error Messages

Depending on the system configuration (if ERR3000 is loaded), the messages listed
in Table 4-1 may be displayed indicating that an error condition exists which will
affect the system's performance. A message is usually accompanied by one or
more beeps, after which the system returns to its previous status.
The actual wording of the messages may be changed by the application program,
so regard the messages here as representative. Some or all of these messages may
also be disabled by the application. Refer to the application documentation for fur-
ther information.
Message
Double Key
Error
Low Battery
Replace Cells
Power Fault
4 - 2
Table 4 - 1 Error Messages
Explanation
Two or more keys were pressed at the same
time. This does not include boot sequences
(see Chapter 3).
The battery pack should be recharged or
replaced as soon as possible.
Replace or recharge the battery pack
immediately. After this message is displayed,
the system shuts off. You will not be able to
power it on again until the battery pack is
charged.
The last power off was caused by a power
failure. This occurs, for example, if the battery
pack is removed while the 3300 is on or the
batteries fail suddenly.