Kenmore 29" Installation Instructions Manual page 9

4-wire Power Supply Cord Connection
IMPORTANT:
A 4-wire connection is required for mobile homes and
where local codes do not permit the use of 3-wire connections.
4-wire receptacle
(NEMA type 14-30R)
Spade terminals with
upturned ends
1.
Prepare to connect neutral ground
wire and neutral wire
Remove center terminal block screw (B). Remove neutral ground wire
(E) from external ground conductor screw (A).
2.
Connect neutral ground wire and
neutral wire
Connect neutral ground wire (E) and neutral wire (white) (C) of power
supply cord under center terminal block screw (B). Tighten screw.
4-prong plug
Ring terminals
E
A
B
E
B
C
3.
Connect ground wire
A
F
Connect ground wire (F) (green or bare) of power supply cord to
external ground conductor screw (A). Tighten screw.
4.
Connect remaining wires
Connect remaining wires to outer terminal block screws. Tighten
screws. Finally, reinsert tab of terminal block cover into slot of dryer
rear panel. Secure cover with hold-down screw. Now, go to "Venting
Requirements."
3-wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground conductor to
neutral wire.
3-wire receptacle (NEMA type
10-30R)
Spade terminals with
upturned ends
3-prong plug
Ring terminals
9