Winnebago Minnie Owner's Manual page 42

Hide thumbs Also See for Minnie:
Table of Contents

Advertisement

SECTION 2
DRIVING YOUR MOTOR HOME
Semi-Manual Mode and or Crank Mode.
ERROR CODES
#Flashes
Problem
1
Unit Timed Out
3
Battery Voltage less
than 10 volts
4
Battery Voltage less
than 8 volts
5
Battery Voltage
greater than 18 volts
6
Stall on Rear Actua-
tor only
7
Stall on Front Actua-
tor only
8
Short Detect on Rear
Motor
9
Short Detect on Front
Motor
10
No Current Detect on
Rear Motor
11
No Current Detect on
Front Motor
12
No Encoder Signal
detected on Rear
Actuator
13
No Encoder Signal
detected on Front
Actuator
14
Rear Actuator did not
re-sync with Front
Actuator within 5
seconds
15
Front Actuator did
not re-sync with Rear
Actuator within 5
seconds
Note: Manual Mode and corresponding Front and Rear Actuator
locations
2-18
Description
(ran for 60 sec with-
out reaching end of
stroke)
(detected when move
requested)
(detected during
move)
(detected when move
requested)
(Indicates obstruc-
tion at rear of room
or jam)
(Indicates obstruc-
tion at front of room
or jam)
(Rear motor is faulty
or wiring harness
faulty)
(Front motor is faulty
or wiring harness
faulty)
(Rear motor is faulty
or wiring harness
faulty)
(Front motor is faulty
or wiring harness
faulty)
(Faulty encoder/har-
ness)
(Faulty encoder/har-
ness)
Front Actuator: Retract/In button
Rear Actuator: Extend/Out button
See your dealer for service of the slideout
system before using again.
Further Information
See the Kwikee DigiSync Slideout Room
operating guide included in your Owner's Info-
Case for further instructions and troubleshooting
information.
Bedroom Slideout Emergency
Retraction Procedure - Model 329B
1. Locate the tools in the right front side stor-
age compartment - a rachet wrench, a hex-
end shaft and an extension shaft. (The ratchet
wrench may be packaged in the Owner Info-
Case.)
2. Locate the small, round access hole in the
bed base at the foot of the bed.
3. Attach the shaft extension to hex-end shaft
and place the ratchet wrench onto the hex
end shaft, then insert into the hole in the bed
base as shown.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spirit

Table of Contents