Table of Contents
Advertisement
Connections and Setup
1.3 Connections
Caution:
L When you operate this product, the power outlet
should be near the product and easily
accessible.
1 Power cord
L Connect to a power outlet
(120 V, 60 Hz).
2 Telephone line cord
L Connect to a single telephone line jack (RJ11C).
3 [EXT] jack
L You can connect an answering machine or an
extension telephone. Remove the stopper if
attached.
4 Answering machine (not included)
5 Handset unit (optional) connection jack
L You can connect the optional handset unit.
Remove the seal if attached.
6 Network router/Network hub (not included)
L Also connect networked computers.
7 To the internet
8 LAN cable (not included)
L To assure continued emission limit compliance,
use only shielded LAN cable (category 5 straight
cable).
1
Important notice for the USB connection
L Do NOT connect the USB cable until prompted by
the Multi-Function Station (page 11).
Note:
L If any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device.
5
3
9
2
4
8
7
6
9
Detailed operating instructions are on the CD-ROM.
1. Introduction and Preparation
Using surge protectors
L The warranty does not cover damage due to power
line surges or lightning. For additional protection, we
recommend using surge protectors (9).
1.4 Dialing mode
If you cannot dial, change this setting according to your
telephone line service.
1
{MENU} i {#}{1}{2}{0}
2
Press {1} or {2} to select the desired setting.
{1} "PULSE": For rotary/pulse dial service.
{2} "TONE" (default): For tone dial service.
3
{SET}
4
Press {MENU} to exit.
1.5 Selecting the operation mode
(Scan/Copy/Fax)
You can select the desired mode by pressing one of the
following buttons.
– {SCAN}: Select this mode when using the unit as a
scanner for the computer.
– {COPY}: Select this mode when using the unit as a
copier.
– {FAX}: Select this mode when using the unit as a fax
machine.
DIALING MODE
=TONE
[V^]
9
Advertisement
Table of Contents
