CONTENTS CONTENTS GENERAL INFORMATION ..............3 Symbols used in this manual ......................3 Using and keeping the manual ....................3 WARNINGS ..................4 USE ......................5 Precautions ............................5 Control panel ..........................5 Hotplate ............................6 3.3.1 Selecting the burner ............................6 3.3.2 Electronic ignition hotplate (depending on model) ................... 7 3.3.3 Manual ignition hotplate ..........................
GENERAL INFORMATION GENERAL INFORMATION Symbols used in this manual Below are shown the various symbols used in the manual to highlight particularly important information. The safety symbols draw attention to potential hazards for personal safety. Absolutely respect all safety messages by following these symbols. WARNING Risk of injury or death.
WARNINGS WARNINGS Do not use or store flammable materials in the appliance storage drawer or near this appliance. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not modify this appliance. Where this appliance is installed in marine craft or in caravans, it shall NOT be used as a space heater. This appliance shall be installed only by authorised persons and in accordance with the manufacturer’s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, AS 5601-2004 - Gas Installations and any other statutory regulations.
3. USE Precautions CAUTION This appliance must only be used by responsible adults. During use and immediately after use the burner and other accessible parts may be hot; do not touch these parts and always keep children at a safe distance. After using the appliance ensure the CAUTION knob/knobs are off.
The following symbols are for burner flame regulation and correspond to the position of the knob. NOTE: Different models could have similar knobs and symbols. Gas off High flame Low flame Electric hotplate off 1 - 2 - 3 - 4 - 5 - 6 Oven and/or electric hotplate temperature Grill OTHER SYMBOLS...
3. USE 3.3.2 Electronic ignition hotplate (depending on model) WARNING Make sure there are no pans or any other objects on the burners when igniting. WARNING To ignite the burner, gently push in and turn the control knob to position HIGH FLAME and, keeping the knob pushed in, at the same time press the electronic ignition pushbutton.
3.4.1 Electronic ignition oven To ignite the burner, push in and turn the control knob to a position from 1 to 6 and, keeping the knob pushed in, at the same time press the electronic ignition pushbutton (for models that have affixed to the oven door the electronic ignition button is not visible and is activated by pressing the gas knob down).
3.5.3 Flame regulation grill For models CU311 - CU311M - CU333 - CU333M - CU335 - CU335M - FO311: the grill is to be used only at its maximum capacity. For all other models: to regulate flame, turn the knob to the desired cooking flame.
Electric hotplate (depending on model) CAUTION Before turning on the electric hotplate (or if the hotplate has remained unused for a long time) it is necessary to eliminate any moisture by turning on the hotplate and leaving it on for 30 minutes with the corresponding knob in position 1. CAUTION Use pans with flat bottoms and with diameters no less than the diameter of the hotplate.
3. USE CAUTION Hot surfaces may be damaged on contact with cold water or with a wet cloth. Do not use abrasive, corrosive or chlorine-based products, pot scourers or steel wool. Do not leave acid or alkaline substances (vinegar, salt, lemon juice, etc.) on the surfaces CAUTION of the appliance.
INSTALLATION Dimensions of the appliance The overall dimensions are illustrated in FIG. 5 - PG. 21 with the cavity diagrams. The overall dimensions include the trivet (pan support), control knobs, handles and gas connection. Fitting cavity WARNING The appliance must fitted at an appropriate and safe distance from flammable materials.
4. INSTALLATION To connect the appliance use a 1.5 mm double red and black wire and wire to the terminal junction box located at the rear of the appliance with the wording “+12 V – “. The red terminal is the positive pole and the black terminal is the negative pole.
INSTALLATION 4.6.1 Test point For models PI... MO... CU... The test point is supplied loose with the appliance (see picture in FIG. 7 - PG. 31). Remove one burner head, injector and screw in test point fitting. The pressure is measured with the relevant burner gas valve on high flame and with an inlet pressure of 2.75 kPa.
5. SERVICING SERVICING WARNING The servicing shall be carried out only by authorized personnel. WARNING WARNING Do not modify this appliance. WARNING WARNING Before any servicing intervention shut off gas supply, disconnect all the electrical power supplies and remove the appliance. WARNING Hotplate: burners, injectors, thermocouples and ceramic igniters 1.
Page 18
SERVICING 9. Remove the ceramic igniter. 10. Remove the grill burner mounting screws (2) from top. 11. Remove the grill burner mounting spacers (only for CU4... models) and lower burner. Gas cocks 1. Remove the control knob by pulling. 2. Unscrew gas cock retaining nut. 3.
Page 21
FIGURES AND TECHNICAL DRAWINGS Figure 5 CU311 CU333 CU335 FRONT VIEW SIDE VIEW 500 mm 415 mm MIN. 45 mm MIN. 460 mm CU311M CU333M CU335M FRONT VIEW SIDE VIEW 524 mm 500 mm...
Page 22
FIGURES AND TECHNICAL DRAWINGS CU401 CU401PE TOP VIEW FRONT VIEW SIDE VIEW 488 mm 479 mm MIN. 494 mm MIN. 21 mm 25 mm 20 mm 488 mm 20 mm MIN. 500 mm CU402 CU402PE TOP VIEW MIN. 494 mm FRONT VIEW SIDE VIEW 488 mm...
Page 23
FIGURES AND TECHNICAL DRAWINGS FO311 FRONT VIEW SIDE VIEW MIN. 480 mm 500 mm PI0913 PI0913A 486 mm 35 mm PI8002 PI8022 233 mm 233 mm 358 mm 466 mm...
Page 24
FIGURES AND TECHNICAL DRAWINGS PI8003 PI8023 273 mm 273 mm 428 mm 546 mm PI8403 - PI8403GL 572 mm PI8423 - PI8423GL PI8443 - PI8463 220 mm 205 mm 76 mm 135° 90° 199 mm 202 mm 70 mm SEZ. A-A PI8621A 3 mm PI8621R...
Page 25
FIGURES AND TECHNICAL DRAWINGS MO8103 MO8123 956 mm 478 mm 478 mm 448 mm 448 mm 421.7 mm 421.7 mm 129.8 mm 29.8 mm 253 mm 33.9 mm SEZ. A-A 225 mm 275 mm VN555 FRONT VIEW SIDE VIEW 486 mm MIN.
Page 26
FIGURES AND TECHNICAL DRAWINGS Figure 6 CU311 CU333 CU335 190 mm CU311M CU335M CU333M 210 mm...