Table of Contents
Advertisement
S
S
UPER
ERVER 6015C-M3/6015C-MT User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 6015C-M3/6015C-MT lies the X7DCL-3/X7DCL-i, a
single processor serverboard based on Intel's 5100 chipset and designed to provide
maximum performance. Below are the main features of the X7DCL-3/X7DCL-i.
Processors
The X7DCL-3/X7DCL-i supports dual Intel
processors in LGA771 sockets. Please refer to our web site for a complete listing
of supported processors (www.supermicro.com).
Memory
The X7DCL-3/X7DCL-i has six 240-pin DIMM sockets that can support up to 48
GB of registered ECC DDR2-667/533 SDRAM. Memory must be installed in an
interleaved (dual-channel) confi guration. All memory modules used to populate the
system should be the same size, type and speed. See Chapter 5 for details.
Onboard SAS (6015C-M3)
An onboard LSI 1068E SAS controller in integrated into the X7DCL-3. The hot-
swappable SAS drives are connected to a backplane that provides power, bus
termination and confi guration settings.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the SAS drives. RAID 0, 1, 5 and 10 are
supported.
Serial ATA
The South Bridge (ICH9R) of the 5100 chipset includes a Serial ATA controller.
The hot-swappable SATA drives are connected to a backplane that provides power,
bus termination and confi guration settings.
Note: The operating system you use must have RAID support to enable the
hot-swap capability and RAID function of the SAS drives. RAID 0, 1, and 10 are
supported.
PCI Expansion Slots
The X7DCL-3/X7DCL-i has two PCI-Express x8 slots, one PCI-Express x4 slot (in a
x8 slot) and three 32-bit, 33 MHz (5V) PCI slots. In the 6015C-M3/6015C-MT server
confi guration, a PCI-E riser card (CSE-RR1U-E8) has been installed to support a
single PCI-Express add-on card.
®
5400, 5300, 5200 or 5100 Series
1-2
Advertisement
Table of Contents
