Table of Contents
Advertisement
WHIRLPOOL CONSUMER SERVICES
FAULT DIAGNOSIS
1.
The diagnostic tests must be performed on the machine without a wash load because the
out of balance detection system is disabled.
2.
Set the cycle selector to "DRAIN"
3.
Press :
a)
"RINSE HOLD" button twice
b)
"INTENSIVE RINSE" button twice
c)
"START" button once,
4.
The control panel will now display :
•
1000 speed LED on (Does not change for duration of the test sequence).
•
"PREWASH" programme sequence LED on
•
"WASH" programme sequence LED on
•
"RINSE" programme sequence LED on
•
"RINSE HOLD" programme sequence LED on
•
"DRAIN/SPIN" programme sequence LED on - (This is Step 1 in the Table over)
5.
Drain pump runs for approximately six seconds and the test sequence automatically
advances to Step 2.
6.
By pressing the Prewash button once, the timer advances to step 3
Model AWM6100
Page 18 of 22
Hide quick links:
Advertisement
Table of Contents
