Polaris 2013 RANGER 500 Midsize Owners Manual/Install Manual page 31

Instrument Cluster
Rider Information Center
Diagnostic Mode
Battery Voltage Screen
View this screen to check battery voltage level.
Tachometer Screen
View the tachometer to check engine speed.
AWD Diagnostic Screen
The gauge indicates whether or not current is flowing through the AWD coil (only on models
with switchable AWD). This screen is for informational purposes only. Please see your
dealer for all major repairs.
Gear Circuit Diagnostic Screen
This screen displays the resistance value (in ohms) being read at the gear switch input of the
gauge. This screen is for informational purposes only. Please see your dealer for all major
repairs.
Programmable service interval
When the hours of engine operation equal the programmed service interval setting, the
wrench icon will flash for 5 seconds each time the engine is started. When this feature is
enabled, it provides a convenient reminder to perform routine maintenance.
The service interval is programmed at 50 hours at the factory.
To enable or disable the service interval:
1. Enter the diagnostic mode.
2. Toggle to the service interval screen.
3. Press and hold the mode button for about seven (7) seconds, until either ON or OFF
appears in the Rider Information Center, depending on your preference.
To reset the service interval:
1. Enter the diagnostic mode.
2. Toggle to the service interval screen.
3. Press and hold the mode button for 2-3 seconds, until the wrench icon flashes. Release
the button.
4. Press and release the mode button once to advance the setting by one hour. Press and
hold the mode button to advance the hours quickly. If you scroll past the intended num-
ber, press and hold the button until the hours cycle back to zero.
5. When the desired setting is displayed, wait until the wrench icon stops flashing. The new
service interval is now programmed.
FEATURES AND CONTROLS
27