Trane FD145CLFR000D Installation Operation & Maintenance page 2

Installer's Guide
4 4 4 4 4
9 9 9 9 9
1 1 1 1 1
Unpack the Air Cleaner and check to make sure all
components are included. They consist of:
1) PRE-FILTER - traps large particles such as hair and
lint before they can enter the cell section.
2) FIELD CHARGER - Charges the contaminants.
to be removed, cleaned or serviced by a qualified
technician.
3) COLLECTION CELL (2) - removes and collects very
small impurities from the air.
4) CABINET - mounts between the furnace/air handler
and return air ductwork and houses the COLLEC-
TION CELLS, FIELD CHARGER and PRE-FILTER.
5) POWER DOOR - the solid state power supply compo-
nents that convert the 24 Volt AC to the high-voltage,
direct current required to power the FIELD CHARGER
and COLLECTION CELLS. Allows access to the
COLLECTION CELLS, FIELD CHARGER and PRE-
FILTER.
The whole house air cleaner can be installed either as
part of a Communicating heating and air conditioning
system or as part of a traditional 24 volt system.
When installed as part of a Communicating System in
which the indoor unit, outdoor unit, and 900 series
comfort control are equipped with our exclusive
Communicating technology, this system performs a
continuous loop of system diagnostics and data output.
The Communicating System monitors itself and quickly
identifies any operational faults, automatically issuing a
service alert if needed.
The whole house air cleaner can also be installed as
part of a traditional 24 volt heating and air conditioning
system.
2
3 3 3 3 3
2 2 2 2 2
Figure 1 Components of the Air Cleaner
Only
Numbers in [brackets] are for 50 Hz international systems.
5 5 5 5 5
6 6 6 6 6
8 8 8 8 8
7 7 7 7 7
6) TRANSFORMER - supplies 24 Volts to the indoor unit
and air cleaner
(not included with 50 Hz units)
7) 24 VOLT POWER/CONTROL CABLE
8) GASKET, LITERATURE AND HARDWARE PACKET
9) UPFLOW AIR HANDLER BAFFLE - This baffle is only
included with Air Handler models. See note below.
NOTE: Be careful not to discard the baffle. It is
located under the collection cells in the
shipping box.
Check carefully for any shipping damage. This must be
reported to and claims made against the transportation
company immediately. Check to be sure all major
components are in the unit. Any missing parts should
be reported to your supplier at once, and replaced with
authorized parts only.
NOTE: International (50 Hz) Timings:
Due to differences in electrical systems outside the
United States, customers with 50 Hz electrical
systems will need to be aware of minor differences
in the timings shown in this guide. 50 Hz timings
will appear in [brackets] following the standard 60 hz
timings.
1 1 1 1 1 2 2 2 2 2 3 3 3 3 3
Pub. No. 18-HE53D1-11