Securing; Securing In Bsr1 Mode With The Button «Start/Stop; Securing In Bsr2 Mode - Bernina 740 Manual

BERNINA Stitch Regulator (BSR)
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot (see page 112).

11.7 Securing

Securing in BSR1 mode with the button «Start/Stop»
Prerequisite:
•
•
> Lower the feed dog.
> Lower the presser foot.
> Press the button «Needle up/down» twice.
> Hold the upper and the bobbin thread.
> Press the button «Start/Stop».
> Sew 5 – 6 securing stitches.
> Press the button «Start/Stop».
> Cut the thread.

Securing in BSR2 mode

Prerequisite:
•
•
> Lower the presser foot.
> Press the button «Securing».
> Press the foot control or the button «Start/Stop».
By moving the fabric some short securing stitches are sewn, then the programmed stitch length is activated
and the securing function is deactivated automatically.
114
The BSR presser foot is attached and connected with the machine.
The BSR display is opened and the BSR1 mode is activated.
– The bobbin thread is brought up.
– Start the BSR mode.
– The BSR mode stops.
BSR presser foot is attached and connected with the machine.
The BSR display is open and the BSR2 mode is activated.
036044.50.04_2014-09_Manual_740_EN