Bosch WAP24200UC Use And Care Manual page 31

Problem Possible cause(s) Solution(s)
Water cannot be seen The water level in your high effi- No action needed.
in the drum. ciencey front load washer is below
the visible part of the drum, this is
normal.
Water has not drained Suds may be excessive (usually Use less detergent for future loads. Be sure to use
completely, due to too much detergent or non- only high efficiency HE-detergents.
HE detergent being used).
No spin is selected. In order to exit the cycle, set the cycle selector to
Spin/Drain or select a spin speed range, then press
the Start/Pause button.
Pump is blocked. Check and clean the drain pump, water drain hose
and/or the drain pipe.
Drain hose or drain pipe is blocked. Clean drainage pipe and/or drainage hose.
Water is coming out Water supply hose is leaking: is not Eliminate the cause: tighten the hose (by hand at the
from the underneath screwed on tight at both ends, or washer end), check for rubber washer in place.
the washer, rubber washer not placed in hose.
Drain hose is leaking. Check the drain hose, be sure that it is on the washer
Foam comes out of the
detergent dispenser
drawer.
The cyle status
sequence Wash flashes
in the display.
Repeated spinning.
securely with the clamp in place; may need to replace
the drain hose if leaking continues.
Immediate fix: mix 1 tablesponful of fabric softener
with 1/2 liter (1 pint) of water and pour this mixture
into the detergent compartment (not with waterproof
fabrics).
To prevent: use less detergent for future wash loads.
No spin took place
(laundry is still wet).
Detergent residue on
the laundry.
System shakes or
shudders when spin
speed increases.
Too much detergent was used, or a
non-HE detergent was used; pump
was not able to pump out the
increased suds.
The Unbalanced Load Detection
system ia attempting to balance the
load through repeated spins.
Load size to small.
Large items may have become
entangled in the drum and could
not be distributed by the Unbal-
anced Load Detection system; spin
cycle therefore canceled for safety
reasons.
Excessive suds: too much deter-
gent was used, or a non-HE deter-
gent was used.
Some phosphate-free detergents
contain water-insoluble residues
may appear as light spots on the
laundry.
The washer drum suspension sys-
tem shifts during spinning as the
speed increases. This may result in
a slight shaking of the washer
during the spin speed transition.
To prevent: always load the washer with a mixture of
large and small wash items (easier to distribute in the
drum).
Add more laundry.
To prevent: always load the washer with a mixture of
large and small wash items (easier to distribute in the
drum).
Immediate fix: mix 1 tablesponful of fabric softener
with 1/2 liter (1 pint) of water and pour this mixture
into the detergent compartment (not with waterproof
fabrics).
To prevent: use less detergent for future wash loads.
Brush off when laundry is dry or
execute the program Rinse.
Mix small and large laundry items together in the load
to minimize this effect. Check to be sure the washer is
level and all four feet press equally against the floor.
Transport bolts removed?
---> Remove the transport bolts; Page 12
31