Bosch WAP24200UC Use And Care Manual page 13

turnedoff ifthe washer is goingto be unused for
extended periodsof time.
Makesurerubber washers areinplaceatbothendsof
the watersupplyhose.Missing washers couldcause
leaks.
o Theconnection pointsareunderfull waterpressure.
Turnonthe watertap andcheckfor leaks.
o Periodically inspectthewatersupplyhoseandreplace
witha newhoseif cuts,kinksor leaksareobserved.
Types of drainage hookups
Standpipe
Water connection hoses
o red - Hot water-hose
o blue - Cold water-hose
Attach this end to water tap. Hand tighten only.
Attach the drain hose using the elbow included with your
washer.
Fit the drain hose to the elbow provided leaving a
maximum of 4 inches of drain hose projecting. Insert this
section of the drain hose into the drain pipe. Secure the
elbow and hose with a nylon tie strap or the equivalent to
keep the hose from coming out of the drain pipe during
use.
Sink siphon
Secure the drain hose to the sink siphon using a O 0.9 -
1.6 in. (20-44 mm) hose clip (available from a hardware
store).
Wash Basin
WARNING
SCALDING
When washing at high temperatures, there is a risk
of scalding if you touch hot suds, e.g. when
pumping out hot suds into a wash basin.
Do not reach into the hot suds.
Attach this end of the hose to the back of the washing
machine. Hand tighten only.
Water drain hose connection
NOTICES
o Do not reuse an old drain hose. Only use the drain
hose and parts included with your washer.
o Do not kink or modify the water drain hose.
Height of drain point
Height difference between the floor and drainage point:
max. 39 in. (100 cm).
CAUTION
@
@
@
APPLIANCE DAMAGE/DAMAGE TO TEXTILES
If the end of the drain hose is dipped into the
pumped-out water, water can be sucked back into
the appliance and can damage the appliance/
textiles.
Make sure that:
The sealing plugs do not seal the drain of the wash
basin.
The end of the drain hose does not dip into the
pumped-out water.
The water flows out fast enough.
13